Tarnish-Me-Not® - Anti-Allergy Jewelry Spray

Carefully follow the instructions below on how to use Tarnish-Me-Not.

• Be sure to properly prepare your jewelry before spraying. Gently clean your pieces and lay flat for best results.
• Do not shake. The unique composition of this formula performs best when contents in the can are still, as opposed to shaken up.
• Hold can upright 5-6" from jewelry.
• Spray in a continuous and even motion until item is coated thoroughly.
• Allow up to 15 minutes for dry-to-touch and an additional 15 minutes to handle.
• Turn item over to spray any remaining surface areas.
• Repeat as needed until coated thoroughly - two coats maximum, which is highly suggested for long lasting protection.
• For best results, spray item in a room temperature, and non-humid environment.
• Finally, enjoy! Once you have completely sealed your jewelry and allowed optimal dry time, you may begin wearing it right away.

Gently wipe down your jewelry to remove any dust, residue or fingerprints to ensure a clean surface for spraying.

This will prevent any fogging due to unwanted particles being trapped beneath the coating. Be sure to lay your jewelry completely flat for easier application and even results.

If you are unhappy with the overall finish of your jewelry after the coating has dried, simply wipe it off with acetone and reapply following the preparation steps.

Gloves are only recommended to those wearing nail polish at the time of spraying.

Avoid contact between polished nails and Tarnish-Me-Not to prevent smudging or removal of nail polish.

Of course! Tarnish-Me-Not® has been thoroughly tested and approved by the Department of Dermatology and Toxicology. The test results indicated that this formula is 100% Hypoallergenic.

Since 2013, this formula has undergone more than 1,300 successful experiments.

These experiments include:

• Laboratory Testing (Corrosion Resistance, UV Ray Exposure)
• Placebo Focus Group Testing
• Controlled Focus Group Testing
• Wear and Tear Experimental Testing
• Weather Testing

You can spray an average of 8-12 pieces of jewelry with two coats per piece.

This measurement considers the 8-12 pieces to be a variety of average sized necklaces, earrings, bracelets and rings.

When spraying larger pieces, such as over-sized statement necklaces, the quantity of pieces per bottle may be less. While spraying smaller items, such as rings, will allow a larger quantity of pieces per bottle.

We recommend Tarnish-Me-Not to be reapplied every three months to jewelry that is worn regularly. For occasionally worn pieces, it is recommended to reapply the coating every six months.

The time duration before suggested reapplication varies by how often the jewelry is exposed to certain wear-and-tear factors; such as: water, humidity, sweat, skin oils, cosmetic products and UV rays. Customers that are more susceptible to skin allergies are advised to reapply the coating more often; one to three months for regularly worn items, and every four to six months for occasionally used items. While other customers, less susceptible to skin allergies, have reported spraying their jewelry only once every 12 months.

Of course! Tarnish-Me-Not will have you wearing your jewelry in moments that you never could have before – while you shower, wash your hands, sleep and even exercise.

Our protective coating gets you through all your daily activities, without fear of tarnishing or skin allergies.